Skip to content
Phone Guides

Check keypad-tone handling before an IVR change

Record whether each leg uses RTP telephone-event, SIP INFO or in-band audio for keypad digits. Check the provider’s supported method and the active payload mapping where RTP events are used.

Keypad-tone handling before an IVR change

  1. Choose a test IVR and digits that cannot trigger a purchase or other consequential action. Save the current endpoint and trunk settings before changing them.
  2. Test a short sequence and a repeated digit from a representative handset and softphone, noting where either leg transcodes.

A successful call setup does not prove that keypad digits survive the media path.

Check the wider path

Agree on a method for every leg rather than setting a phone option in isolation. A PBX or SBC can translate between methods, and a carrier may accept only certain forms. Test digits through the actual external route before changing the whole fleet.

Use the DTMF guide: how phone keypad tones work in VoIP to confirm terms and settings before the change.